How to skillfully control the gear lever of Howo truck to shift gears?

Abstract:Today we will talk about the gear shifting skills of Howo truck gear lever.

The shift lever is called the transmission lever, which is customarily referred to as the gear and the gear lever. Other common names are gear stick, gear lever, and shifter. Its function is to shift gears according to driving conditions. By changing the gearing of the gears in the transmission, the driving speed of the vehicle is changed, and the driving force is also changed. It is a tool that changes moving parts from one speed to another.

It is important for the car to shift gears correctly. Correct shifting during driving can effectively increase the power of the engine, save fuel, and extend the service life of the car.

Use road speed (miles per hour):

According to the vehicle speed, start from the first gear, drive a certain distance and then change to 2 gear.

When the vehicle speed reaches 20 miles above 35 miles, put in 3rd gear.

When the vehicle speed reaches 35 miles above 45 miles, put in 4th gear.

When the vehicle speed reaches above 45 mph, shift to 5th gear.

The above is an ordinary 5th gear car. For cars with 6 gears or more, one gear can be added every 15 miles.

If you understand the gear speed of the car, you can learn to use the sound of the engine to distinguish when to shift gears.

It is also important to master the correct shift hand type. Some drivers ignore the hand type of shifting and use only two 3 fingers to shift gears, which is very irregular and unsafe. The correct operation should be to cover the target's head with the palm of your hand down, hold the head with 5 fingers, and let the rear shift be performed.

When shifting gears, be sure to step on the clutch to the end. Avoid lifting the clutch without clamping this wheel, which will cause great damage to the transmission.

Uphill skills:

1. When the car enters the normal driving route, it will immediately accelerate to a low speed range one gear higher than this gear. When the clutch is lifted and refueling, the engine and the vehicle will not shake. If the engine and the vehicle shake, It means that the speed is low, and the speed should be increased again.

2. If the vehicle has a recoil phenomenon, it means that the speed increase is too high. At this time, the gear lever should be quickly shifted to a higher gear so that the speed will be increased later.

3. If the ramp is relatively long, you should keep the low gear and the high throttle, and go uphill at an average speed. The gear lever is in the normal gear, and the car should be driven up the top of the slope. Do not change the gear repeatedly.

Downhill skills:

1. Keep it low. If you find a long slope to go down, the truck driver should put the speed into low gear in advance and let it go down slowly.

2. Look at the speed and step on the brake, don't keep braking. If the downhill speed is too fast, step on the brake to a foot stuffy, quickly shift into the resistance. Do not use the point brake type for braking, because the point brake may cause the brake to overheat and the air pressure is too low, causing the brake to fail.